How To Measure For A Round Fitted Tablecloth In Revit Family

How to Measure for a Round Fitted Tablecloth in Revit Family

Creating a custom-fitted tablecloth for a round table in Revit Family requires precise measurements. Follow these steps to ensure a perfect fit:

Step 1: Measure the Table Diameter

Use a measuring tape to determine the diameter of the round table. Measure from edge to edge across the widest part of the table.

Step 2: Determine the Overhang

Decide on the desired overhang, the amount of tablecloth that will extend beyond the table edge. A typical overhang is 6-12 inches. Add twice the desired overhang to the table diameter.

Step 3: Calculate the Fabric Width

Cut a piece of fabric that is equal to the calculated diameter. For example, if the table diameter is 48 inches and the overhang is 8 inches, the fabric width would be 48 + (2 x 8) = 64 inches.

Step 4: Measure the Table Height

Measure the height of the table from the floor to the top of the table surface. This measurement will determine the length of the fabric's drop.

Step 5: Calculate the Fabric Length

To calculate the fabric length, add the table height to the desired drop. For example, if the table height is 30 inches and the desired drop is 15 inches, the fabric length would be 30 + 15 = 45 inches.

Additional Considerations:

Seam Allowance: Allow an additional 1-2 inches for seam allowance around the edges of the fabric.

Bias Cut: For a better fit, cut the fabric on the bias. This means cutting at a 45-degree angle to the fabric's grain.

Shape Adjustments: If the table has an unusual shape, you may need to make adjustments to the measurements. Measure the table carefully and allow for any overhang or drop.

By following these steps, you can accurately measure for and create a custom-fitted tablecloth that will enhance the aesthetic appeal of your round table in Revit Family.